This lab is based on the application of circuit analysis techniques to a capacitive circuit in Multisim.ġ. Make sure to answer the questions in step 5. Save the analysis from step 1 & 2 and simulation results from step 4 along with the table and screen captures of all the measurements. What was the effect of removing the dependent source from the circuit? Does the overall power supplied or power dissipated change?Ĥ. Is the supplied power distributed among all the components in the circuit? Show that total power supplied is equal to the sum of powers dissipated in each component.ģ.
Are the measured values same as calculated values? If not, explain why they are different?Ģ.
Take the screen capture for the measurements of current and power supplied and dissipated by each resistor and complete the table above.ġ. (Use 5% tolerances for each of the resistors)Ĭ. Next, remove the dependent source ‘5 i1’ from the circuit and run the simulation again to record the measurements in the table. (Use 5% tolerances for each of the resistors)ī. Run the simulation to measure the current ‘ i1’ and power supplied by 1V source record the measurements in the table. Construct Figure 4.73 from Chapter 4 in Multisim.Ī. Fill in the calculated values in the table below:Ĥ. Redo the problem, this time without the dependent current source ‘ 5i1’.ģ. Work Exercise 48 from Chapter 4 to determine the current ‘ i1’ and power supplied by 1V source.Ģ. You will learn to utilize Multisim to perform the mesh analysis.ġ. This week’s lab is based on the application of circuit analysis techniques to a resistive circuit in Multisim.
0 kommentar(er)
